10.If the radio cannot start normally after installing it: 1) For Fiat series, please first swap B1/B2 and connect the yellow B+ wire.
2)Please connect the red ACC wire and the yellow B+ wire of the Isudar power cable to see if the radio starts to rule out whether it is a Canbus problem or a radio problem.
Ⅱ.T68B:
Factory setting password:1617
1. If the screen touch fails or the touch response is reversed:
* Find a wired mouse and connect it to the 4 Pin USB port, then use the mouse cursor to click the following path to enter the settings: CarSetting>Factory Setting (Password:1617)>Touch Study>Touch Calibration, Then you need to click the screen position with your finger instead of clicking the mouse.
2. If you are unable to view the video, the system is closed by default for driving safety:
* You need to set it to open as follows: Car Setting >General Setting >Hand
1. If the screen touch fails or the touch response is reversed:
* Find a wired mouse and connect it to the 4 Pin USB port, then use the mouse cursor to click the following path to enter the settings: CarSetting>Factory Setting (Password:1617)>Touch Study>Touch Calibration, Then you need to click the screen position with your finger instead of clicking the mouse.
2. If you are unable to view the video, the system is closed by default for driving safety:
* You need to set it to open as follows: Car Setting >General Setting >Hand
10.If the radio cannot start normally after installing it: 1) For Fiat series, please first swap B1/B2 and connect the yellow B+ wire.
2)Please connect the red ACC wire and the yellow B+ wire of the Isudar power cable to see if the radio starts to rule out whether it is a Canbus problem or a radio problem.
Ⅱ.T68B:
Factory setting password:1617
1. If the screen touch fails or the touch response is reversed:
* Find a wired mouse and connect it to the 4 Pin USB port, then use the mouse cursor to click the following path to enter the settings: CarSetting>Factory Setting (Password:1617)>Touch Study>Touch Calibration, Then you need to click the screen position with your finger instead of clicking the mouse.
2. If you are unable to view the video, the system is closed by default for driving safety:
* You need to set it to open as follows: Car Setting >General Setting >Hand
1. If the screen touch fails or the touch response is reversed:
* Find a wired mouse and connect it to the 4 Pin USB port, then use the mouse cursor to click the following path to enter the settings: CarSetting>Factory Setting (Password:1617)>Touch Study>Touch Calibration, Then you need to click the screen position with your finger instead of clicking the mouse.
2. If you are unable to view the video, the system is closed by default for driving safety:
* You need to set it to open as follows: Car Setting >General Setting >Hand
← Older Post Newer Post →
0 comments